THORENS TD-150 - Page 16

To stop the turntable:
@ Gently move the pick-up arm control to the “ High " position.
© Return the arm to the rest post.
© Pull the * On-Off" knob to the “ Off" position.
Maintenance
© Cleaning the belt and pulleys
For perfect functioning of the drive system of the TD-150 turntable, the belt, the motor pulley
ind the periphery of the inner turntable should be entirely free from any trace of oil or grease. If
necessary, clean them with a clean rag impregnated with denatured alcohol.
See Fig. 10 for the correct position of the belt. The belt will be centred in the control fork only
when the outer 12 * turntable platter is in position.
nips
Fig. 10.
©
Turntable
spindle
The
turntable
spindle
revolves
on
self-lubricating
bushings
and
on
a
nylon
thrust
plat
normal
conditions,
lubrication
is
not
necessary
before
several
thousand
hours
running.
Use
exclusively
Caltex
or
Texaco
Regal
Oil
B
(ROB),
as
supplied
with
our
lubrication
kit
available
as
an
accessory
at
your
franchised
dealer.
©
Motor
The
slow
speed
double
synchronous
motor
does
not
normally
require
any
lubrication
during
its
lifetime.
rs