EasyManuals Logo

THORLABS CS165 Series User Manual

THORLABS CS165 Series
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Compact Scientific Digital Cameras Chapter 3: Setup & Installation
Page 10 ITN004347-D02
3.2.4. Installing 3
rd
Party Software Application Support
After installation of Thorlabs components is complete, you have access to interfaces for select 3
rd
-party image
analysis packages you may already have installed on your computer, such as MATLAB
®
.
3
rd
-party application software interfaces are located in Zip files in the following directory:
C:\Program Files\Thorlabs\Scientific Imaging\Scientific Camera Support
Important: Do not develop 3
rd
-party solutions in this directory, as they will be deleted if you update your
ThorCam software.
To use the MATLAB and LabVIEW interfaces, extract from the Zip file and place in the appropriate directory on
your system.
Special note for users of Micro-Manager (µManager) software: support for Thorlabs scientific cameras (excluding
the CS505MUP polarization camera) is included when you run versions 2.0 and later. If you wish to download or
update your Micro-Manager software, please visit
https://micro-manager.org/wiki/Micro-Manager_Open_Source_Microscopy_Software
Before using your camera within Micro-Manager, first make sure that your camera is properly installed and powered-
on. You may run a session of ThorCam to confirm that the camera, software and drivers are properly installed.
Then, shut down your ThorCam session and start a Micro-Manager session.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the THORLABS CS165 Series and is the answer not in the manual?

THORLABS CS165 Series Specifications

General IconGeneral
BrandTHORLABS
ModelCS165 Series
CategoryDigital Camera
LanguageEnglish

Related product manuals