© 2021 Thorlabs
1 General Information
3
To avoid risk of fire, only the appropriate fuses for the corresponding line voltage must
be used.
All modules must only be operated with proper shielded connection cables.
Attention
The following statement applies to the products covered in this manual, unless other-
wise specified herein. The statement for other products will appear in the respective ac-
companying documentation.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules and meets all requirements of the Canadian
Interference-Causing Equipment Standard ICES-003 for digital apparatus. These limits
are designed to provide reasonable protection against harmful interference in a residen-
tial installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful in-
terference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the re-
ceiver is connected.
· Consult the dealer or an experienced radio/T.V. technician for help.
Users that change or modify the product described in this manual in a way not expressly
approved by Thorlabs (party responsible for compliance) could void the user’s authority
to operate the equipment.
Thorlabs GmbH is not responsible for any radio television interference caused by modi-
fications of this equipment or the substitution or attachment of connecting cables and
equipment other than those specified by Thorlabs GmbH. The correction of interference
caused by such unauthorized modification, substitution or attachment will be the re-
sponsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to any and all
optional peripheral or host devices. Failure to do so may violate FCC and ICES rules.
Attention
Mobile telephones, cellular phones or other radio transmitters must not be used within
the range of three meters of this unit since the electromagnetic field intensity may then
exceed the maximum allowed disturbance values according to IEC61326-1.
This product has been tested and found complying with the limits according to IEC
61326-1 for using connection cables shorter than or equal to 3 meters (9.8 feet).
Warning
Laser modules can deliver up to several 100mW of even invisible laser radiation! When
operated incorrectly, this can cause severe damage to your eyes and health! Be ensure
to pay strict attention to the safety recommendations of the appropriate laser safety
class, as stated for the used light source.
To Next Page
Loading...
Need help?
General
