© 2021 Thorlabs2
LDC200C Series
1 General Information
As a part of Thorlabs Green Initiative, we aim to save paper and decided to offer electronic doc-
umentation to our products. This Quick Reference gives only a short introduction and states
safety and legal information.
The full manual can be downloaded in PDF format from the LDC200C Series product web site,
or simply by scanning the QR code:
Note
In order to prevent damages to the laser diode, it is recommended to mount the laser
into a suitable Thorlabs laser diode mount and connect it to the LDC200C Series using
the supplied Thorlabs CAB400 cable. This ensures the utmost protection of the laser di-
ode from damage by wrong connection.
1.1 Safety
Attention
The safety of any system incorporating the equipment is the responsibility of the assem-
bler of the system.
All statements regarding safety of operation and technical data in this instruction manual
will only apply when the unit is operated correctly as it was designed for.
The LDC200C Series must not be operated in explosion endangered environments!
Do not obstruct the air ventilation slots in the housing!
Do not remove covers!
Do not open the cabinet. There are no parts serviceable by the operator inside!
This precision device is only serviceable if properly packed into the complete original
packaging including the plastic foam sleeves. If necessary, ask for replacement pack-
aging.
Refer servicing to qualified personnel!
Only with written consent from Thorlabs may changes to single components be made or
components not supplied by Thorlabs be used.
Attention
Prior to applying power to the LDC200C Series, make sure that the protective conductor
of the 3 conductor mains power cord is correctly connected to the protective earth
ground contact of the socket outlet! Improper grounding can cause electric shock result-
ing in damage to your health or even death!
Ensure that the line voltage setting of the fuse holder at the rear panel agrees with your
local supply and that the corresponding fuses are inserted. If not, please change the line
voltage setting (see section Line voltage setting) and the mains fuses (see section Re-
placing the main fuses).
To Next Page
Loading...
Need help?
General
