EasyManuals Logo

THORLABS MTD415T User Manual

THORLABS MTD415T
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
© 2016 Thorlabs GmbH
6 Programmers Reference
19
MTD415T Data Sheet Rev. 1.0
Further, with default setting of the Safety Bitmask (value = 255), the states of bits 0 to 7 are
handed over to the Status output pin - if any of the bits 0 to 7 is H, the Status level is "LOW"
and the TEC Current Output is switched off.
The Safety Bitmask can be used to mask any desired error at the Status output pin.
Attention
Masking an error may lead to damage of the MTD415T. For example, if bit 1 is masked,
exceeding the internal temperature will not be reflected on the status pin as an error and the
TEC output will not be disabled!
The safety bitmask can be programmed:
Command
Explanation
Response Example
Programming
"Sx"
Sets the Safety Bitmask to x
Value range x: 0 to 32768
Reading
"S?"
Reads the Safety Bitmask value.
[x<LF>]
Note
If the safety bitmask should be saved for future use, it needs to be memorized using the "M"
command.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the THORLABS MTD415T and is the answer not in the manual?

THORLABS MTD415T Specifications

General IconGeneral
BrandTHORLABS
ModelMTD415T
CategoryTemperature Controller
LanguageEnglish

Related product manuals