Compact Stabilized Light Sources Chapter 2: Safety
Page 2 CTN002682-D02
Chapter 2 Safety
The lamp comes with a switching power supply compatible with voltages from 100
to 240 VAC. There is no need to change the fuse.
WARNING
Do not operate this device in explosive environments.
WARNING
Do not operate this device in wet or damp conditions.
WARNING
Do NOT look directly at the light source beam during operation. Do NOT place
hand or body part in the light beam as this may cause burning.
CAUTION: HOT SURFACE
The housing of the lamp housing can get very hot during operation.
Extensive contact may cause burning.
WARNING: HOT SURFACE
The temperature of the bulb may reach a few hundred ˚C during operation.
Always wait for at least 10 minutes for the bulb module to cool down before
performing a bulb module replacement. Always wear gloves when handling bulb
modules.
To Next Page
Loading...
Need help?
General
