63
1. Go to:
https://support.thrustmaster.com/product/T598p/.
2. Download and install the PC driver in the Drivers
section and the My Thrustmaster Panel software in
the Software section.
3. Once the PC driver has been installed, connect the
double jack/RJ12 cable to the RJ12 connector on the
base and the Raceline Pedals LTE pedal set.
The jack connector with the B marking (Brake)
connects to the brake pedal. The jack connector with
the G marking (Gas) connects to the accelerator pedal.
4. Connect the USB-C/USB-A cable to the base’s
USB-C port, and a USB-A port on the PC.
5. Connect the power adapter to the base, and also plug
it into a wall outlet.
6. Press the On/Off button located at the back of the
base.
To Next Page
Loading...
