SWITCHING FROM THE “H-PATTERN (7+1)” SHIFT PLATE
TO THE “SEQUENTIAL (+/-)” SHIFT PLATE
1. Unscrew (counterclockwise) and remove the gear shift knob (A).
2. Using the included 2.5 mm Allen key (E), completely unscrew and remove the 4 screws
holding the “H-pattern (7+1)” shift plate in place. Remove the shift plate.
During this procedure, take care not to accidentally let
any of the screws fall inside the internal mechanism.
3. Manually rotate the internal structure 90° to the right (clockwise).
Next, install the “Sequential (+/-)” shift plate.
To Next Page
Loading...
