1
a. Remove the truck, radio, and accessories from box.
b. To unlock zip-tie, press on the small lever. Pull on the zip-tie while keeping the small lever pressed.
Pull the zip-tie out completely.
c. Insert the (PD1502) wheel hex driver into both sides of the front/ rear wheel.
d. Install the wheel assembly, lining up the roll pin with the slot in the wheel. Thread on the locknut and
washer using nut wrench supplied.
e. Install the flag onto the mount with the attached screw in the bag.
UNRAPPING THE TRUCK FROM BOX
AND INSTALLING THE TIRE & FLAG
2
a
cb
d e
WARNING
Thank you for purchasing a Thunder Tiger Product. Please read all instructions thoroughly before operation.
1. This product is not a toy. It is a high performance model product. It is important to familiarize yourself with the
model, its manual, and its construction before assembly or operation.
2. Do not operate model products in rain, on public roads, near crowds, near airport, or near areas with restricted
radio operation.
3. Always keep fuel away from heat, open flame and the reach of children! Only operate in open, well-ventilated
area. Store fuel in cool, dry area. Keep the fuel bottle cap tightly closed. Clean up any leak or excess fuel before
starting the engine.
4. This product, its parts, and its construction tools can be harmful to your health. Always exercise extreme caution
when assembling and/or operating this product. Do not touch any part of model which rotates.
5. Check your radio frequency with the proper operating frequency of the area or country. Always check to see if
there are any modelers operating on the same frequency as your are. Also, check your radio for proper operation
before operating a mode.
6. Improper operations may cause personal and/or property damage. Thunder Tiger and its distributor have no
control over damage resulting from shipping, improper construction, or improper usage.
7. Thunder Tiger assumes and accepts no responsibility for personal and/or property damages resulting from the
use of improper building materials, equipment and operations. By the act of assembling or operating this product,
the user accepts all resulting liability. If the buyer is not prepared to accept this liability, then he/she should
return this kit in new, unassembled, and unused condition to the place of purchase.
To Next Page
Loading...
Need help?
General
