18
CANOPY, PROP, CONTROL THROWS
XII. Canopy
❐ Put instrument panel stickers in place.
❐ Using a pair of Lexan scissors,trim the canopy along the faint mold line.
❐ Trial fit the canopy on the cockpit. When satisfied with fit,glue it
in place with Formula 560 Canopy Glue, trim with striping tape and
set aside for 24 hours.
XIII. Prop and Spinner
❐ Install the prop. We are using an APC 15x8 to go with TT PRO-120
engine.
❐ Attach the spinner. Depending on the prop you use,you may have
to modify the spinner openings.
XIV. Control Throws
These control throws are merely a starting point for your radio setup
and can be tailored to fit your flying style.
To Next Page
Loading...
