6
WING ASSEMBLY
I. Mount Servos
❐ With the wing panel upside down,locate the servo well and cut an
X from corner to corner using an Xacto knife.
❐ Use a sealing iron to tack down the covering inside the servo well.
❐ With the wing rightside up, locate the servo wire exit hole and
remove covering.
❐ Attach the 12" aileron extension lead to the servo.
❐ Install the servo in the wing. Use a servo arm instead of the
standard wheel.
❐ Use a piece of clear tape to temporarily hold the servo pigtail to the
wing to prevent it from slipping back into the wing while you are
working.
II. Install Ailerons
❐ Remove the aileron and insert T-pins into the centers of the hinges.
Install aileron onto the wing,remove T-pins,and apply thin CA to the
hinges (both sides).
To Next Page
Loading...
