10
Turn it back on
INSTALLING REMOTE CONTROL BATTERY
Preparing the remote control
The provided Remote Control allows the unit to be operated from a distance. Even if the Remote Control is
operated within the effective range (6m), Remote Control operation may be impossible if there are any obsta-
cles between the unit and the Remote Control. If the Remote Control is operated near other products which
generate infrared rays, or if other Remote Control devices using infrared rays are used near the unit, it may
operate incorrectly. Conversely, the other products may operate incorrectly.
Replace the remote control battery
1
Use a needle to push the battery forward through the hole on rear of remote control.
2
Remove the old battery. Place a new CR2025 battery with correct polarity (+/-) as indicated. Then install
the battery into the remote control.
1 2
Precautions concerning batteries
• When the Remote Control is not to be used for a long time (more than a month), remove the battery from
the Remote Control to prevent it from leaking.
• If the batteries leak, wipe away the leakage inside the battery compartment and replace the batteries with
new ones.
• Do not use any batteries other than those speci ed.
• Do not heat or disassemble batteries. Never throw them in re or water.
• Do not carry or store batteries with other metallic objects. Doing so could cause batteries to short circuit,
leak or explode.
• Never recharge a battery unless it is con rmed to be a rechargeable type.
To Next Page
Loading...