14
Turn it back on
TROUBLE SHOOTING
To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this
unit, check the following points before requesting service.
No power
• Ensure that the AC cord of the EVO-2 is connected properly.
• Ensure that there is power at the AC outlet.
• Press standby button to turn the unit on.
Remote control does not work
• Before you press any function button, rst select the correct source.
• Reduce the distance between the remote control and the unit.
• Insert the battery with its polarities (+/-) aligned as indicated.
• Replace the battery.
• Aim the remote control directly at the sensor on the front of the unit.
Poor radio reception
• Increase the distance between the unit and your TV or VCR.
Clock setting erased
• Power has been interrupted or the power cord has been disconnected.
• Reset the clock.
Using iPhone to play music
• While the iPhone is playing the music through the dock, there may be a chance that the iPhone may not
receive a good signal to get the incoming call.
No response from the unit
• Disconnect and reconnect the AC power plug, then turn on the unit again.
To Next Page
Loading...