Tibo EVO-2 - Adjust sound and display; Tuning a FM station

13
Turn it back on
BASIC OPERATION
Tip:
• If there’s an existing connection, hold and press “

/ “ button on remote control for a few seconds and
the unit will re-activate the pairing mode, the connection will be interrupted.
• If there’s no other Bluetooth device paired with the unit in two minutes, the unit will return to previous
connection.
• The unit will also be disconnected when your device is moved beyond the operational range.
• If you want to reconnect your device to the unit, place it within the operational range.
• If the device is moved beyond the operational range, when it is brought back, please check if the device is
still connected with the unit.
• If they are connected, display panel shows “BLU T”.
• If the connection is lost, display panel shows “NO BT”, follow the instruction above to pair your device to
the player again.
Listen to music from a Bluetooth Device
If the connected Bluetooth device supports Advanced Audio Distribution Pro le (A2DP), you can listen to the
music stored on the device through the player. If the device also supports Audio Video Remote Control Pro le
(AVRCP), you can use the player’s remote control to play music stored on the device.
1. Pair your device with the player.
2. Start play music via your device (if it support A2DP).
3. Use supplied remote control to control play(if it support AVRCP).
• To pause/resume play, press the “

/ “button.
• To skip to a track, press the

/

buttons.
Adjust sound Level
During play, press the +/- buttons to increase/decrease volume level.
Mute sound
During play, press the MUTE button to mute or resume sound. Press this button again or -/+ buttons to cancel
the effect.
Adjust the brightness level of display
In standby mode, press the

/

button on the remote control to adjust the brightness level of display.
Tuning a FM station
1. Press the FUNCTION button to select the TUNER source.
2. Press and hold the

/

buttons (until the digits move), then release the button, the frequency changes
down or up automatically until a station is found.
3. Repeat steps 2-3 to tune more stations.
Note: The unit will automatically switch from Stereo or MONO to receive the FM radio station.
Presetting Stations
You can preset up to 20 FM stations. Program radio stations automatically press and hold the M/Clock button
for seconds to activate automatic programming. All available stations are programmed in the order of wave-
band reception strength. The  rst programed radio station is played automatically.
Press the

/

buttons to skip to previous/next preset radio station.
Note: If the system is unplugged or if a power failure occurs, the preset stations will not be erased.