TIDALFIT START-UP
INSPECTION
You will want to inspect your TidalFit, prior to lling it up with water. Look
for and remove any debris in the pool tub and in the lter. Verify that pump
plugs are installed on the pumps and the pump unions are tight.
FILLING THE TIDALFIT WITH WATER
NOTE: Do Not ll your TidalFit with hot water straight out of your
water heater or tap. This water may be as hot as 180ºF and will cause
damage to the surface and plumbing of the pool. This will void your
warranty. Level the pool before lling.
1) Prepare to ll the tub by removing all debris.
2) Remove the lters from your pool (see Removing, Installing and Clean-
ing Filters, page 52.)
3) Place your garden hose in the center of the lter .
4) Fill the tub from the circulation pump line until water level is above
the foot-well.
NOTE: This will purge all the air out of the circulation pump. An air
lock can cause damage to the circulation pump and is not covered
under warranty.
5) Once the water level is lled over the foot-well, you can pull the hose
out of the lter line and continue lling the pool from the lter well.
6) Fill the pool to the bottom of the pillows.
NOTE: Do Not Overll Your Pool.
7) With the front panel off, verify there are no leaks at the pump union.
NOTE: Pump unions can become loose during shipping. Verify that
there are no leaks during lling of the pool.
8) Reinstall the circulation pump screen and all lters.
TURNING THE POWER ON
Turn the power to the pool on at the main circuit breaker. Verify that your
pool has no error codes. Verify that there is good water circulation in the
pool. The pumps will come on in cycles, for 1 minute each cycle.
23
To Next Page
Loading...