44
TOPSIDE CONTROL INSTRUCTIONS
SENSOR-RELATED/MISC. MESSAGES
Flow-Related Checks
Check for low water level, suction ow restriction (lters) closed valve or
trapped air.
The heater is too hot* – M030
One of the water temperature has detected 118°F (47.8°C) in the heater
and the spa is shut down. You must clear the message when water is be-
low 108°F (42.2°C).
Flow-Related Checks
Check for low water level, suction ow restriction (lters) closed valve or
trapped air.
SENSOR RELATED MESSAGES
Sensors are out of sync – M015
The temperature sensors may be out of sync. Call you dealer for service.
Sensors are out of sync -- Call for service – M026
The temperature sensors are out of sync. Call you dealer for service.
Sensor A Fault, Senor B Fault – Sensor A: M031, Sensor B: M032
The temperature sensors or sensor circuit has failed. Call you dealer for
service
MISCELLANEOUS MESSAGES
Communications error
The control panel is not receiving communication from the system. Call
your dealer for service.
Test software installed
The Control System is operating with test software. Call your dealer for
service.
°F or °C is replaced by °T
The Control System is in Test Mode. Call your dealer for service.
To Next Page
Loading...