TIDALFIT START-UP
PRIMING THE PUMP
1) Turn off power at electrical service panel.
2) Locate and loosen one of the pump plugs on each pump by turning it
counterclockwise one half of one turn.
3) Allow air to escape from ttings. When a steady stream of water ows
from the pump plug, close it by turning it clockwise until tight.
4) Turn on power at electrical service panel.
5) Check once more to make sure that water is owing from the jets during
auto purge. If so, continue. If no water is coming from your spa jets, please
call your Artesian dealer for further assistance.
WATER PREPARATION
NOTE: Before putting your new pool into operation, understand
that preparing your new water is an important part of maintenance.
Failure to properly prepare your water can result in substantially de-
creasing the life of the components and may void your warranty in
severe cases. Your Artesian dealer should have a start-up and main-
tenance kit available for you when you receive your pool.
25
To Next Page
Loading...
