DIAGNOSTIC MESSAGES
Temperature unknown.
• After the pump has been running for 1 minute, the
temperature will be displayed.
Temperature not current in Economy or Sleep mode.
• In Economy or Sleep mode, the pump may be off for
hours outside a lter. If you wish to see the current
pool temperature, either switch to Standard mode or
turn Jets1 on for at least a minute.
Standby mode has been activated by pressing a but-
ton combination on the user panel.
• Press any button, except “Jets 1” to leave Standby
Mode and return to normal operation.
pH is low.
• Add pH increaser according to manufacturer’s in-
structions.
pH is high.
• Add pH reducer according to manufacturer’s instruc-
tions.
or
Sanitizer is low.
• Add sanitizer according to manufacturer’s instruc-
tions.
Sanitizer is high.
• Remove pool cover and allow sanitizer to dissipate.
The pump is on during Standby Mode to assist in
draining the pool.
• Press “Jets 1” to turn off the pump when water has
drained (or power off the pool.).
Hardware failure.
• Contact your dealer or service organization.
50
To Next Page
Loading...
