3.9 SET AND USE PARAMETER
PRESS <SET/0~9>3 SECONDS，ENTER SET AND SHOW MAIN MENU，PRESS <SET/0~9> CONTINUOUS，
IT DISPLAYS：
rAngE(SET LIMIT)
UnItS(CHOOSE UNIT)
A- OFF（CHOOSE AUTO POWER OFF）
FILt(SET DISPLAY MODE)
ZEro(SET AUTO ZERO)
bUZZE(SET BUZZLE)
d(CHOOSE DIVISION)
LU-( BRIGHTNESS ADJUSTING)
3.9.1 rAngE(SET UPPER AND LOW LIMIT)
3.9.1.1 WHEN IT SHOWS rAngE， PRESS <TARE> ENTER TO SET LIMIT，PRESS <SET/0~9> TO
CHOOSE on OR oFF, on IS START LIMIT FUNCTION，Off IS EXIT LIMIT FUNCTION，PRESS
<TARE> TO CONFIRM.
3.9.1.2 WHEN CHOOSE on AND PRESS <TARE>，NOW ENTER TO SET LIMIT，“UNDER” LAMP IS
LIGHTING , MAX FIGURE IS
BLINKING，PRESS<SET/0~9> ONCE TO ADD 1，PRESS <TARE> TO CONFIRM，WHEN
FINISHING AUTO EXIT AND SET
“OVER”(SAME AS SET UNDER LIMIT).AFTER FINISH SETTING INTO WEIGHING.
3.9.1.3 WHEN LOW LIMIT > HIGH LIMIT, IT DISPLAYS OFF, THEN EXIT.
3.9.1.4 ALARMING INDICATE:m IS THE WEIGHT
WHEN m≥HIGH LIMIT, “OVER” LAMP IS LIGHTING AND FLICKERING.
WHEN LOW LIMIT < m < HIGH LIMIT，“ACCEPT” LAMP IS LIGHTING(NOT FLICKERING).
WHEN m≤LOW LIMIT, “UNDER” LAMP IS LIGHTING.
CAUTION：WHEN THE DISPLAY IS NOT STABILIZATION, NO LAMP LIGHTS.
3.9.2 UnItS(CHOOSE UNIT)
3.9.2.1 WHEN IT DISPLAYS UnItS，PRESS <TARE> TO ENTER，PRESS <SET/0~9> TO CHANGE，PRESS
<TARE> TO CONFIRM. UNITS：
H9(KG)、PcS（COUNTING）、Lb.Lb(DECIMAL POUNDS)
3.9.2.2 COUNTING：WHEN IT DISPLAYS “PCS”, PRESS<TARE>. NOW “PCS” LAMP LIGHTING.
LONGTIME PRESS<ON/ZERO>, IT DISPLAYS COUNT AND RETURN TO 0. THEN PUT THE
SAMPLE (AS MUCH AS
POSSIBLE,BUT DON’T MORE THAN MAX.CAPACITY), AFTER STABLE, PRESS<TARE>.
PRESS <SET/0~9> TO ADD 1
To Next Page
Loading...
