IM2019
20
Note: In the fan operation mode, the temperature settings are non-effective.
FAN OPERATION MODE
1. Press the MODE button, select the fan operation mode.
2. By pressing the SPEED button, you can select the fan speed from LOW, MID, HIGH, AUTO.
3. Press the ON/OFF button, the air-conditioner starts to operate.
4. Press the ON/OFF button again, the air-conditioner stops.
Note: In the fan operation mode, the temperature settings are non-effective.
DRYING OPERATION MODE
1. Press the MODE button, select the drying operation mode.
2. Press the ON/OFF button, the air-conditioner starts to operate.
3. Press the ON/OFF button again, the air-conditioner stops.
BACKLIGHT FUNCTION (for remote controllers with such function only)
The remote control has a backlight which can be turned on by pressing any button for the
convenience of operation in darkness. The backlight will be automatically turned off if there is no
operation within 10 seconds.
11. MAINTENANCE
Before cleaning unplug the conditioner.
Cleaning of the indoor unit and remote control board:
Indoor unit and remote control should be cleaned with a dry soft cloth.
If the indoor unit is too unclean, moisten the cloth and squeeze it well.
In order to avoid the damage of paint or parts of the conditioner, do not clean it with
brushes and do not leave them on the surface of indoor unit.
In order to avoid the damage of surface or deformation of the conditioner parts, do not
clean it with petrol, solvents, cleaning powders or other chemically active substances.
Before a long break in use of the conditioner:
Turn the conditioner on for several hours in the FAN mode. It will dry its inner cavities.
Unplug the conditioner.
Remove the batteries from the remote control.