IM2019
19
15. ANTI-FUNGUS - Starting the automatic drying mode of the indoor unit.
16. DISPLAY - Press this button to turn on/off the display. Indication of the remote control
display shall correspond to selected modes.
* The appearance of the remote control, as well as the buttons and indicators may differ from the
image in the manual, but their functions are identical
Operation with remote control
Mounting and replacement of batteries: mount two AAA alkaline batteries, according to polarity
indicated on the remote control. In order to avoid malfunction of the remote control do not insert
used batteries or batteries of various types. If the conditioner is not used for a long time, remove
batteries from the remote control or else electrolyte may leak and damage the board. In normal
operation of the conditioner average service life of batteries will be about a half-year. Do not
dispose of batteries in regular garbage bins; they should be disposed of in special bins at
garbage collection points.
Replace batteries, if command receiving is not confirmed with an audio signal, or if the display
does not show a sign of command transfer. When generating commands from the remote control
point an IR emitter at a remote-control signal receiver situated on the indoor unit. Hold the
remote control board at the distance of no more than 8 m from the indoor unit.
The remote control will not work if there are curtains, doors or other objects between it and the
indoor unit. Do not allow water to enter the remote control and do not expose it to direct sunlight
and heat sources; direct the IR emitter to the remote control signal receiver located on the indoor
unit.
10. OPERATING MODES
AUTOMATIC OPERATION MODE
1. Press the MODE button, select the automatic operation mode.
2. By pressing the SPEED button, you can select the fan speed from LOW, MID, HIGH, AUTO.
3. Press the ON/OFF button, the air-conditioner starts to operate.
4. Press the ON/OFF button again, the air-conditioner stops.
Note: In the fan operation mode, the temperature settings are non-effective.
COOLING/HEATING OPERATION MODE
1. Press the MODE button, select the Cooling or Heating operation mode.
2. By pressing the « » or « » button, you can set the temperature range from 16°C (60°F) ~
32°C (90°F), the display changes as you touch the button.
3. By pressing the SPEED button, you can select the fan speed from LOW, MID, HIGH, AUTO.
4. Press the ON/OFF button, the air-conditioner starts to operate.
5. Press the ON/OFF button again, the air-conditioner stops.
To Next Page
Loading...
Need help?
General
