Programming across midnight
• Enter the required programme 1 ON time.
• Set the programme 1 OFF time to 00:00
(i.e. midnight).
• Set the programme 2 ON time to 00:00 as well.
• Enter the required programme 2 OFF time
for the next day.
Modifying or adding programmes
• Press and hold the Prg button for 3 seconds,
the word Hold will show on the screen.
• After 3 seconds release the Prg button and
the MODE screen will be displayed.
Note: This will automatically display
the mode in which it was last programmed.
For instance, if it was programmed in 5 + 2,
then it will show Mo Tu We Th Fr.
• Either – Accept this by pressing the Prg
button once, and review the programmed
times for this mode by pressing Prg to move
through the times.
• Or – Press the Adv/Over or Boost button to
change the mode, and then press the Prg
button to review the times.
Note: If you wish to change the mode
at this stage, doing so will result in
programmes being lost and they
will need to be re-entered.
• Review times and adjust as necessary
as described at the start of section 9.
To Next Page
Loading...
Need help?
General
