Timex T100 - Setting Time Zone

10
5. Setting the Minute Printing Format
The T100 will print in standard minutes (60) or in decimal hundredths (100) of
an hour. Decimal hundredths allow time calculations without having to
convert minutes to decimal hours. 12:45 will be printed 12:45 in the
standard minute format or as 12.75 if hundredths is chosen.
•
Press <AM IN> once to set the minute printing format (60 min or Decimal
100ths)
(press<AM IN> 4 times if just entering programming mode).
•
Press <OT IN> to change between “
Cd
60
” (Min) and “
Cd
100
” (Decimal
100ths).
•
Press <OT OUT> to save.
Note: The clock will only display in the Minute format.
6. Setting the Day Change Time
0:00 (Midnight) is the default time for the day change. The T100 will begin
printing on the next line of the time card (for the next workday) at this time.
•
Press <AM IN> once to set the day change time
(press <AM IN> 5 times if
just entering programming mode)
.
• Press <PM OUT> to advance the hour (00~23h) of the day change.
•
Press <OT OUT> to save.
7. Setting Time Zone
•
Press <AM IN> once to set Time Zone
(press <AM IN> 6 times if just
entering programming mode).
The display reads “
-5
E ST
”.
• Press <OT IN> to select time zone.
•
Press <OT OUT> to save.