14
11.
Setting the Signal Tone Times
The T100 allows for 32 scheduled audible signals. If you set a signal it will
occur every day and sound for the set signal duration.
Following is a sample schedule of events for an 8:00 AM to 5:00 PM work
schedule with one hour lunch from 12:00 Noon to 1:00 PM (13:00). This
schedule has four signals.
Event (Max 32) Signal Tone Description
1 08:00 Start of Work
2 12:00 Start of Lunch
3 13:00 End of Lunch
4 17:00 End of Work
Note: A signal cannot be set at 0:00. Setting an existing color change
event to 0:00 can be used to remove an individual event within a
schedule.
•
Press <AM IN> once to set the audible schedule
(If entering
programming mode begin at “Inputting the Default Password” section &
continue to this step)
. The display shows “
01 00:00
”.
• Press <PM OUT> to advance the hour of the event.
•
Press <OT IN> to advance the minute of the event.
• Press <OT OUT> to save and advance to the next scheduled event,
(example “02 12:00”).
•
Repeat as necessary until all desired events are set.
To Next Page
Loading...
