6
V. Setting the T100
Programming Outline
The following is a reference list of the programming order and defaults.
Reminder: Pressing <AM IN> allows you to skip unnecessary steps. The
numbers below match the numbers of the detail programming steps:
Enter programming mode
1. Set pay period and current print line (Default: Weekly)
2. Set time (Default: Eastern Standard Time)
3. Set year, month and date (Default: Eastern Standard Time)
4. Set 12 or 24 hour print format (Default: 12 hour)
5. Set minutes to 60 minute or decimal hundredths (Default: 60 minute)
6. Set the day change time (Default: Midnight)
7. Set Time Zone (Default: Eastern Standard Time)
8. Daylight Saving Time (Default: On)
9. Input default password (Default: 1234)
10. Set 2 color (red/black) printing (Default: N/A, set as desired)
11. Set signal tone times (Default: N/A, set as desired)
12. Set signal tone duration time (Default: 5 seconds)
13. Change default password (Default: 1234, change as desired)
Exit programming mode
If you do not need to change any of the default settings you may proceed to
“Operating the T100” on page 17.
To Next Page
Loading...
