What to do if the DWT full indicator is blinking on my Tineco Washer?
If the dirty water in the Dirty Water Tank (DWT) has reached the MAX line, the DWT full indicator will blink. To resolve this, empty the dirty water and then reinstall the DWT.
How to fix a Tineco FLOOR ONE S3 that does not turn on?
If the appliance does not turn on, it might be due to auto protection for overheating. Allow the appliance to cool down, and then restart it.
How to improve weak suction on a Tineco FLOOR ONE S3 Vacuum Cleaner?
Weak suction can occur if the HEPA filter is not installed or is dirty. Clean and dry the HEPA filter to restore proper suction.
Why is the battery level indicator blinking on my Tineco FLOOR ONE S3 Vacuum Cleaner?
The battery level indicator blinks, accompanied by a voice prompt indicating low battery, when the appliance needs charging. Charge the appliance, or try restarting it.
General| Type | Wet/Dry Vacuum Cleaner |
|---|---|
| Cordless | Yes |
| Battery Type | Lithium-Ion |
| Battery Voltage | 21.6V |
| Run Time | Up to 35 minutes |
| Charging Time | 4-5 hours |
| Clean Water Tank Capacity | 0.6 L |
| Weight | 9.9 lbs |
| Noise Level | 78 dB |
| Smart Features | App Connectivity |
| Display | LED |
| Dustbin Capacity | N/A (collects dirty water) |
Explains the various icons and indicators shown on the digital display of the appliance.
Instructions on how to properly fill the clean water tank with tap water.
Steps for charging the appliance using the provided charging base and adapter.
Details on selecting between AUTO and MAX cleaning modes based on floor dirtiness.
Explanation of the various indicator lights during use and charging.
Information on downloading and using the Tineco app for enhanced functionality.
A table detailing the status messages and corresponding voice prompts from the appliance.
Guidance on cleaning the main body of the appliance and troubleshooting the red LED loop.
Instructions for emptying and cleaning the dirty water tank and removing debris.
Steps for rinsing and cleaning the filter and floater if they become blocked.
Procedure for rinsing the HEPA filter and ensuring it is completely dry before reassembly.
How to initiate and perform the automatic self-cleaning cycle for the brush roller.
Instructions on how to remove and rinse the brush roller cover for cleaning.
Steps for removing, cleaning, and re-installing the brush roller and its chamber.
Information and recommendation for registering the appliance on the Tineco official website.
To Next Page