Tiny Audio C6 - FM Transmission Frequency Selection; Select FM Frequency (Manual Mode)

Side 7
flashing display of “---.-MHZ” and stop at a “vacant”
frequency.
4. After a “vacant” frequency is found, press “TX/SCAN”
button again to confirm and exit setting or it will
automatically confirm and exit the setting after 5
seconds. The selected “vacant” frequency (TX FREQ)
will be shown at the top of the blue bar, e.g.
TX108.0MHz
5. Then tune your car FM radio system to match the
selected “vacant” frequency (TX FREQ) for
transmission of the audio signal from TINY AUDIO C6
to your car stereo audio system.
Remark: To enable FM transmitter, you have to set the device
into “AUX IN” mode.
--Select FM Transmitting Frequency (Manual Mode):
1. Press “TX/SCAN” button to enter FM transmitting
frequency selection mode.
2. Then use Tuning Knob to select your favorite vacant
frequency (based on your past experience with the
known vacant frequency) which you would like to
receive by your car radio.
3. Once it is selected, press “TX/SCAN” button to
confirm and exit or the screen will go back to DAB+
mode automatically after 5 seconds and the selected