INSTALLATION MANUAL
MODEL : TIS-4PL-E66D
NETWORK 4 ZONE AMPLIFIER
2
www.tiscontrol.com
TIS CONTROL LIMITED
Wanchai, Hong Kong
TIS CONTROL PTY LIMITED
SA, AUSTRALIA
Copyright © 2023 TIS, All Rights Reserved
TIS Logo is registered trademark of TIS CONTROL.
All of the specification are subject to change without notice.
SIMPLE INSTALLATION
You can install this module on a wall or
place it on a stable surface.
MOUNTING LOCATION
Position the device on a stable location with
easy access to wiring and terminals.
WARRANTY
There is a Two-Year warranty provided
by law. The hologram warranty seal and
product serial number are available on
each device.
READ INSTRUCTIONS
We recommend that you read this
Instruction Manual before installation.
SAFETY INSTRUCTIONS
Electrical equipment should only be
installed and tted by electrically skilled
persons.
Failure to observe the instructions may
cause damage to the device and other
hazards. These instructions are an
integral part of the product and must
remain with the end customer.
Any issues stemming from an
installation by an unauthorised person
is the responsibility of the user and will
not be covered by warranty.
PROGRAMMING
This device can be tested and
programmed manually. Advanced
programming requires knowledge of
the TIS Device Search software and
instruction in the TIS advanced training
courses.
To Next Page
Loading...