Titan Dynamics
Titan Dynamics Webpage
Visit our Facebook page
Join our Discord server
Page 21 of 28
Section 5: Assembly of 3D Printed Parts
Below are a few exploded views of the Viper to help with assembly.
The spar layout for Viper is as depicted below. None of the spars need to be glued in, they
will all be retained by the printed parts. The two wing spars that intersect the fuselage
are the joiners for the wings and the fuselage and can be removed completely from the
fuselage and wing during transport. The tail can also be removed.
To Next Page
