Titan Implement 7000 Series - Setting the Disc Harrow; Leveling the Frame; Setting the Disc Angle; Adjusting the Width

Titan Implement, LLC 21 7000 Series Disc Harrows
(423) 334-0012 January 2022
5.4 Setting the Disc Harrow
Properly setting the disc harrow is essential for efcient
and safe operation. A properly adjusted disc harrow
will break up the soil more evenly, require minimal
tractor work, and follow the contour of uneven terrain.
5.4.1 Leveling the Frame
1. Use the screw jack on the right lift arm to level the
frame from side-to-side. The frame should be level
when the disc is at working depth.
2. Use the turnbuckle on the top link to level the frame
from front to back. The frame should be parallel to
the ground when the disc is at working depth.
3. Place the 3-point hitch in “oat” operating mode to
allow the machine and the hitch to move up and
down, as required to follow ground contours.
5.4.2 Setting the Disc Angle
The more aggressive the angle of the gangs, the more
aggressive the cutting action in the soil prole will be.
The more aggressive the cutting action is, the more
horsepower will be required to pull the unit.
1. Using the tractor hydraulics, raise the disc harrow
off the ground and lower it onto blocks. Place the
transmission in park or neutral and apply the parking
brake. Shut down the engine and remove the key
before exiting the tractor.
2. Remove the center adjustment bolt.
3. Move the carriage to the desired position.
4. Install the adjustment bolt in the desired hole
location and tighten securely.
NOTE: For a better ground nish, set the rear gangs at
a less aggressive angle than the front gangs.
5.4.3 Adjusting the Width
Width adjustments can be made by loosening the
U-bolts and sliding the disc gangs in or out to the
desired position.
Note: The rear discs should be centered between the
front discs for best performance.