7000 Series Disc Harrows 26 Titan Implement, LLC
January 2022 (423) 334-0012
8. Service and Maintenance
8.1 Maintenance Safety
The following safety instructions are provided to
help prevent serious injury and possibly even death.
Damaged Parts Hazard
Do not use the disc harrow if any
parts are damaged. If the disc
harrow is believed to have a defect which could
cause it to work improperly, immediately stop
using it and remedy the problem before
continuing.
No Unauthorized Modications
Do not modify the disc harrow or safety
devices. Do not weld on the unit.
Unauthorized modications may impair its function
and safety and will void the warranty.
If the disc harrow has been altered in any way from
the original design, the manufacturer does not
accept any liability for injury or warranty.
Proper Support
Use certied safety stands rated to
support the load when performing
repairs, service, or maintenance.
Make sure the jack stands are stable and the disc
harrow is approximately level. Test the stability of
the disc harrow before performing repairs, service,
or maintenance.
If the disc harrow is attached to the tractor, set the
brakes, remove the key, chock the tractor wheels,
and block the disc harrow before performing repairs,
service, or maintenance.
Tighten the lower 3-point arm anti-sway mechanism
to prevent side-to-side movement.
Good Working Condition
Keep all parts in good condition and properly
installed. Fix damage immediately. Replace
worn or broken parts.
OEM
Replacement Parts
If replacement parts are necessary, genuine
factory replacement parts must be used to
restore the unit to its original specications. Titan
Implement will not accept responsibility for damages
as a result of the use of unapproved parts.
The following safety instructions are provided to
help prevent injury or limit equipment damage.
Clean Work Area
Do not leave tools lying around
the work area. Follow good
shop practices. Keep service area clean and dry.
Be sure electrical outlets and tools are properly
grounded. Use adequate light.
Use the Right Tools
Use the correct tools, jacks, hoists, or
other tools that have the capacity for
the job.
8.2 Greasing
Grease the zerks on the axle bearing caps of 7100
Series disc harrows before each use. Use an SAE
multipurpose lithium base grease.
1. Always use a handheld grease gun for all greasing.
2. Wipe grease zerks with a clean cloth before
greasing to avoid injecting dirt and grit.
3. Apply grease until new grease can be seen coming
out of the joint.
4. Do not let excess grease collect on or around parts,
particularly when operating in sandy areas.
5. Replace any broken grease zerk immediately.
6. If any grease zerk will not take grease, remove
and clean it thoroughly. Also clean the lubricant
passageway. Replace the zerk if necessary.
To Next Page
Loading...