Version 2.01 TS132/TS142/TS152 QIG
GAS / DIESEL MODE
M3-1-1 Flash Timed Diesel Mode - Remote Starter will delay 8 seconds with ignition
on before cranking.
M3-1-2 Flashes Timed Diesel Mode - Remote Starter will delay 15 seconds with ignition
on before cranking.
M3-1-3 Flashes Gasoline/Glow Plug Mode - The remote starter will monitor the glow
plug wire for a negative input for up to a maximum of 30 seconds and
then crank. If there is no input on this wire, the unit will crank after
3.5 seconds. Use this mode for Gasoline vehicles or if you are hooking
up a negative glow plug wire on a diesel vehicle.
INSTANT TRIGGER INPUT
M3-2-1 Flash Glow plug line will not instant trigger for start.
M3-2-2 Flashes Glow plug line will function as instant trigger to start and Glow
plug input.
R
UN TIME
M3-3-1 Flash Remote Starter will run for 4 minutes.
M3-3-2 Flashes Remote Starter will run for 30 minutes.
M3-3-3 Flashes Remote Starter will run for 45 minutes.
M3-3-4 Flashes Remote Starter will run for 15 minutes.
TACH SENSING
M3-4-1 Flash Remote starter will detect 4 cycle pulses.
M3-4-2 Flashes Remote starter will sense by altering tach pulse frequency.
M3-4-3 Flashes Remote starter will detect 2 cycle pulses.
READY MODE SETUP ± MANUAL TRANSMISSION ONLY
M3-5-1 Flash Foot & ParkBrake.
M3-5-2 Flashes Park Brake Only.
M3-5-3 Flashes Transmitter Only.
To Next Page
