27
− If necessary, you can cut o excessive material after it has cooled o.
− Repeat the process if the laminating pouch has not adequately adhered to
the document.
5. Move the multi-function switch 1 to “OFF” to switch the laminator o.(ON/OFF).
Cold Lamination
After the laminator has been turned on setting the touch panel on position, the
cold mode is automatically set. Wait until the light on, then can start the cold
laminating.
Reverse function operation
Risk of damage!
Improper handling of the laminator may lead to damage to the laminator
or documents.
− After hot lamination, allow the laminator to cool down suciently
(approx. 20 – 30 minutes) before you use the laminator for cold
laminating.
− Please note that only laminating pouches intended specically for cold
lamination are to be used.
If you want to stop a laminated item jammed during it’s workin, please press the
reverse button.
Burn hazard!
The laminator will become hot during operation.
− Always let the laminator cool o completely before you clean it.
7. Cleaning
Risk of short circuit!
Water that has penetrated the housing may cause a
short circuit.
− Never submerge the laminator in water.
− Make sure that no water penetrates the housing.
To Next Page
Loading...