35
www.titathink.com
[Email Sending] Enable/disable email sending.
[Snapshot Stream] The 1st is big pictures, the 2nd is smaller pictures.
[Email Interval] The time between email sending. Setting the time to 0
disable this feature.
[Server] Type the name or IP address of the SMTP server you want to use
for sending the E-mails. Please note that some networks do not allow e-mail
replaying.
[Port] The port number of the e-mail server(default is 25).Some e-mail
server port is not 25(e.g. Gmail is 465), please check with your e-mail
service provider.
[SSL Connection] If your SMTP email server require SSL connection,
please enable it.
[Authentication] Select whether authentication is required by the SMTP
server
[Account] Your e-mail account you want to use to send the alarm. it should
be entered your full e-mail address. e.g. if your email address is 123@
xx.com, you should enter 123@xx.com.
[Password] The password of your e-mail account
[Sender] Type the e-mail address of the account you are using to send the
e-mail.
[Receiver#1~#3] Type the recipients' e-mail addresses.
[Subject] Subject of the e-mail.
[Message] Type the text you wish to appear in the e-mail.
Tap "Conrm" to save your settings
Notes: Email setting can be obtained from your email service provider. An
SMTP email account is required-these are very common if you use POP3
email and some IMAP servers. A true IMAP server will not work.
Some ISPS won't let you use any other SMTP server other than their own.
On the advanced setting web page. Click "Task" and select "Task
Management", on the Task management page you can enable or disable the
"Email alarm sending" function. And click "Email alarm sending" to congure
alarm email parameters.
For Windows PC or Mac
Please access the camera advanced setting web page to setup the alarm
recording via your computer. Please refer to previous section for how to
access camera advanced setting web page.
To Next Page
Loading...
Need help?
General
