36
www.titathink.com
[Snapshot from] Selet snapshot stream source, "Primary stream" for big
picture, "Secondary stream" for smaller picture.
[Snapshot Duration] The number of seconds that the caemra should keep
sending email with attached image after motion stops.
[Snapshot Frame Rate] The number of frames per seconds that the camera
should keep sending images at when an alarm is triggered.
[Alarm interval] This is the number of seconds for which the camera should
stop sending e-mail alerts after fhe rst set.
[SMTP server name] Type the name or IP address of the SMTP server you
want to use for sending the E-mails. Please note that some networks do not
allow e-mail replaying.
[SMTP server Port] The port number of the e-mail server(default is 25).
Some e-mail server port is not 25(e.g. Gmail is 465), please check with your
e-mail service provider.
[SSL Connection] If your SMTP email server require SSL connection,
please enable it.
[Authentication] Select whether authentication is required by the SMTP
server
[User name] Your e-mail account you want to use to send the alarm. it
should be entered your full e-mail address. e.g. if your email address is
123@xx.com, you should enter 123@xx.com.
[Password] The password of your e-mail account
[Sender mail address ] Type the e-mail address of the account you are
using to send the e-mail.
[Receiver mail address] Type the recipients' e-mail addresses.
[Subject] Subject of the e-mail.
[Message] Type the text you wish to appear in the e-mail.
Tap "Apply" to save your settings
To Next Page
Loading...
Need help?
General
