Titus DVCP - DVHC Diffuser Installation; DVHC Unit Installation Steps; DVHC Commissioning and Balancing

12
Installation Manual-DISPLACEMENT VENTILATION DIFFUSERS
Redefine your comfort zone. ™ | www.titus-hvac.com
IOM
DVCP / DVVC / DVHC
DVBC / DVRI / DVIR
DVHC Installation
STEP 1
Drill the holes on the bottom plate of the unit and the mounting base.
Install the mounting base into place using screws.
STEP 2
Install wall bracket to the wall using screws and slide the bottom of the
unit into the angle wall bracket.
STEP 3
Install wall bracket to the wall to hold the top of the unit using screws.
Commissioning (Balancing): The balancing port is positioned on the side
behind the decor strip. The K-factor of the unit is stated on the K-factor
label mounted on one of the side of the balancing port. The k-factor can
also be found on our website in the relevant k-factor guide. See Figure 4
Figure 3
Figure 1
Figure 4
Figure 2