Our Brands: FlinQ | iProtect | Park Assist | ParkEyes | Siqura | VDG
Installations in over 80 countries
TKH Security B.V. | +31 182 592 333 | info.nl@tkhsecurity.com | tkhsecurity.com
1. Puncture seal in nozzle and remove the pull-tab seal at the bottom of the cartridge. Load into
applicator and fix retaining ring (if applicable). Assemble the nozzle (if applicable) and cut tip
to create between a 1/8” and 1/4” bead taking precaution to be no wider than 1/4”.
2. Dispense product with the nozzle tip in contact with the substrate to insure good gap filling.
3. A continuous bead of adhesive sealant shall be applied approximately 1/3 of the way into the
threads as shown in below illustration.
4. Thread NPT-NPS aluminum adapter coupling on the threated end of the camera mount. Pay
special attention to ensure the NPT threads are going toward the camera mount and the
NPS end is going to the camera.
5. Ensure that the coupling completely covers the adhesive sealant and is locked down tight. It
is suggested that after hand tightening, a pipe wrench is used to gain another ¼ turn or more
if available.
6. When the adhesive sealant is applied properly, and the coupling tightened fully the result
should be a continuous unbroken bead of adhesive sealant at the top of the coupling. This
bead should be in contact with both the top of the coupling and the camera mount as shown
in below two illustrations. While there is no need to remove the exposed adhesive sealant,
the installer may at their discretion decide to smooth off the excess.
The adhesive sealant should be tack-free in 50 – 60 minutes with a full cure occurring at
approximately 24 hours. There is no need to wait for the product to become tack-free before
To Next Page
Loading...