ROUTING SETUP
To change DMX routing settings, set individual port directions (IN or OUT) and select Art-Net universe for
each port. Art-Net universe is displayed in two formats – decimal and hexadecimal (hex value is in brackets).
Use Left/Right to select port. To edit, press OK. Left selects direction field, right selects universe field.
Up/Down changes values. Press OK again to save changes made. To exit, press Right until “EXIT” appears,
then press “OK”.
LOAD CONFIGURATION
To load pre-defined configurations and reset device to its defaults:
1) Config 1 – Sets ports to inputs and sets universes 0 through 3 for each port.
2) Config 2 – Sets ports to outputs and sets universes 0 through 3 for each port.
3) Config 3 – User-configurable preset.
4) Defaults – Resets all device settings, including name and network configuration to defaults.
Default name is “ProPlex IQ One” and default IP is 2.1.1.10.
5) EXIT -- To exit from main Menu.
Use Left/Right to select configuration. To load, press OK and confirm by selecting YES and pressing OK
again. To exit, press Right until “EXIT” appears, then press OK.
To Next Page
Loading...