IQ MENU TREE
To enter Main menu, press OK key. Select sub-menu with Left/Right keys and confirm with OK. To exit
menu, press Right until “EXIT” appears, then and press OK.
NETWORK SETUP
Here you can change Ethernet settings: IP address, Subnet Mask and Gateway. Use Left/Right to select
parameter. To edit, press OK. Up/Down changes value, Left/Right selects field to edit. Press OK again to
save changes made. To exit, press Right until “EXIT” appears, then press OK.
PROTOCOL SETUP
In this Menu you are able to configure the incoming or outgoing protocol (ART-Net or sACN). After selecting
‘Protocol Setup’ from the main menu, press enter to get to the sub menu here you can go left or right on the
key pad to ‘Enable Merging’ or ‘Select Protocol’. Press enter on either and use the arrow keys to select
which protocol or enable / disable merging, press ‘Enter’ when the desired selection is underlined and scroll
to the right to exit this menu.
NETWORK SETUP >
< ROUTING SETUP > < LOAD CONFIG >
< EXIT
< IP >
2 . 1 . 1 . 10
< GATEWAY >
2 . 1 . 1 . 1
< EXIT
DMX port 1 >
Dir IN univ= 0 ( 00 )
< DMX port 2 >
Dir IN univ= 1 ( 01 )
< DMX port 3 >
Dir IN univ = 3 ( 03 )
< DMX port 4 >
Dir IN univ = 4 ( 04 )
< EXIT
Config 1 >
All IN univ 0 - 3
< Config 2 >
All OUT univ 0 - 3
< EXIT
< MASK >
255. 0 . 0 . 0
< PROTOCOL SETUP >
Protocol Select >
Art-Net
<Merging >
Status: Disabled
< EXIT
< User Config 3 >
User Defined
< DEVICE SETUP >
LCD Contrast >
< LCD Backlight >
Settings
< Device Info >
< EXIT
< Front Panel >
Lock
< Art-Net Loss >
< Art-Net Resend >
<Defaults >
reset all defaults
< DMX OUT Rate >
< User Config 4 >
User Defined
To Next Page