TMT Automation Armstrong - General Safety Warnings and Precautions

3
I. General Safety Warnings And Precautions
Please read this instruction manual carefully before the installation of gate-automated
system.
This manual is exclusively for qualied installation personnel.
The manufacturer is not responsible for improper installation and failure to comply with
local electrical and building regulations.
Keep all the components of Armstrong system and this manual for further consultation.
In this manual, please pay extra attention to the contents marked by the symbol:
Be aware of the hazards that may exist in the procedures of installation and operation of
the gate-automated system.
Besides, the installation must be carried out in conformity with local standards and
regulations.
If the system is correctly installed and used following all the standards and regulations, it
will ensure a high degree of safety.
Make sure that the gates works properly before installing the gate-automated system and
conrm the gates are appropriate for the application.
Do not let children operate or play with the gate-automated system.
Do not cross the path of the gate-automated system when operating.
Please keep all the control devices and any other pulse generator away from children to
avoid the gate-automated system being activated accidentally.
Do not make any modifications to any components except that it is mentioned in this
manual.
Do not try to manually open or close the gates before you release the gear motor.
If there is a failure that cannot be solved and is not mentioned in this manual, please
contact qualied installation personnel.
Do not use the gate-automated system before all the procedures and instructions have
been carried out and thoroughly read.
Test the gate-automated system weekly and have qualied installation personnel to check
and maintain the system at least every 6-month.
Install warning signs (if necessary) on the both sides of the gate to warn the people in the
area of potential hazards.
WARNING!