8
this position.
to actually sae this freuency to
- ress button AU for 3 sec
freuency as a station
- ress A to sae the current
station saing mode.
- ress button AU enter the
Display normal play
1.
2.
initial freuency
M Mode
Display normal play
4.
3.
f Select no 9 freuency
M Mode
09 same ith 02
M Mode
S
6. MUTING FUNCTION
Remark : About mute function
hen signal of M 1 appear mute circuit or promptly.
hen signal of M 1 disappear it returns to it preious state
about 3 seconds later.
M 1 has a priority function. hen M 1 input is used it tae precedence
and automatically attenuate the olume of M 2 M 3 M 4 M 5 AU 1
AU 2 inputs by 0 up to 30 d hich i s adustable ith the MU AD on rear
panel. he attenuation leel is preset for –30 d at the factory.
7.1. Input Connections
xM 1 - 5 onnection (hone lug)
ecause M input is electronically balanced type it uses double pole phone plug.
Double ole hone lug
M
o ore Shielded able
Single ole hone lug
M
One ore Shielded able
oeer the microphone input circuit is in a condition of unbalance hen using single pole type.
Since the state of unbalance is more ulnerable for noise generation the recommended length of
microphone cable is at less than 10 meters.
xAU nput onnection (A in ac)
One ore Shielded
Signal source (uner assette ape etc)
xhime Microphone onnection
(Straight thernet lug)
7. CONNECTIONS
M3 layer ndicationOperating Mode
Shielded
RJ45
Connector
in 8 - D
in 7 -
in 6 - ot onnected
in 5 - OM
in 4 - O
in 3 - ot onnected
in 2 - OO-A
in 1 - OO-
To Next Page
Loading...
Need help?
General
