34
M-802RC Editor
2
3
4 5 6 8 9 107
1
1. Select Channel to Control Volume:
-Input Channel: Check the box to control the input of multiple channels at once.
-Output Channel: Check the box to control the input of multiple channels at once.
2. Enable Routing Function
-Output Channel 1 - 12: Check the box to control the routing of multiple output channels at once.
3. Lock System: The user can enter numbers and letters as password and click lock. If he forget the
password that can use factory password: 0000.
Note: No other password can be set after unlocking, you must first lock and then unlock with 0000 to set
a new lock password.
4. Device Name Setting: Click to modify the device name, after modification, click Save To Device to
save.
5. Load From Device: Load presets from device.
6. Save to Device: Save preset parameters to the device.
7. Screen Saver: After checking this box, the machine will sleep after one minute of inactivity.
8. Default: Initialization parameter setting.
9. Load From PC: Load presets from PC.
10. Save To PC: Save current preset.
Attention: The volume can only be switched on the terminal after the PC software is set, and the volume
cannot be adjusted on the terminal
Note: The factory setting is ON. In order to prolong the life of the LC-Display, it is recommended that the
user set it to ON.
To Next Page
Loading...
