TOHATSU BFT 80A - Page 93

91
STARTING THE ENGINE
(H2 type)
7. H type:
Align the “ ” (start mark) on the
throttle grip with the projected end
of the “ ” mark on the tiller
handle.
R1 type:
Leave the fast idle lever in the
START (fully lowered) position.
8. Set the AC generator rotor so the
cutouts are on the right and left
sides of the AC generator rotor as
shown. Hook the knot at the end of
the starter rope (accessory) against
a cutout in the AC generator rotor
and wind the starter rope one and
half turns clockwise along the
groove in the AC generator rotor.
START
THROTTLE GRIP
‘‘ ’’ MARK
EMERGENCY
STARTER ROPE
KNOT
AC GENERATOR ROTOR
CUTOUT
····
·····
·····
(H1 type) (R1 type)
“ ” MARK
THROTTLE
GRIP
START
START
FAST IDLE LEVER
36ZZ0T030_EN.book Page 91 Tuesday, November 28, 2017 4:19 PM