TOHATSU M4C - Tilt Up, Tilt down and Shallow Water Operation

ENGINE OPERATION
Tilt up
7ÌÊÌiÊÃvÌÊiÛiÀÊÊ iÕÌÀ>ÊÀÊ
ÀÜ>À`]ÊvÕÞÊÌÌÊÌiÊÕÌL>À`ÊÌÀÊ
Õ«ÊÌÜ>À`ÊÞÕÊLÞÊ`}ÊÌiÊÌÌÊ
>`iÊ«ÀÛ`i`Ê>ÌÊÌiÊÀi>ÀÊvÊÌiÊÌ«Ê
VÜ°Ê/iÊÃ}ÌÞÊÜiÀÊÌiÊÕÌL>À`Ê
ÌÀÊvÀÊV}Ê>ÌÊÌÌÕ«Ê«ÃÌ°
6. Tilt up, tilt down and shallow water operation
x
Óx
!
7!2.).'
• Do not put hand or finger in
between outboard motor body and
clamp bracket when adjusting trim
angle to prevent injury in case the
outboard motor body falls.
• Unsuitable trim position can cause
loss of control of boat.
When testing a trim position, run
boat slow initially to see if it can be
controlled safely.
!
7!2.).'
Excessive trim up or down may lead
to unstable boat operation, potentially
causing the steering difficulty that
leads to accident during cruising.
• Do not cruise at high speed if
improper trim position is suspected.
Stop the boat and readjust trim
angle before continuing cruise.



!
7!2.).'
When tilting up or down, be careful not
to place your hand between the swivel
bracket and the stern bracket.
Be sure to tilt the outboard motor
down slowly.
Ìi
-Ì«ÊÌiÊi}iÊLivÀiÊÌÌ}ÊÕ«°