INSTALLATION24
5
z Be sure to correctly connect the (+) and
(—) leads. If not, the charging system
will be damaged.
z Do not disconnect the battery leads
from battery while the engine is operat-
ing, the electrical parts could be dam-
aged.
z Always use a fully charged battery.
ENOW00015-0
Do not use a battery that is not recom-
mended. Use of a battery not recom-
mended can lead to poor performance of,
and/or damage to, the electrical system.
ENON00006-A
Note
Recommended battery: 12V 70AH/5HR,
650 (Cold Cranking Amps (CCA), In case of
cold whether: 12V100AH/5HR (850CCA))
Specifications and features of batteries vary
among the manufacturers. Consult the
manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the outboard
motor.
1. Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
2. Connect the positive lead (+) to the
positive terminal (+) of the battery, and
then connect the negative lead (—).
When disconnecting the battery
always remove the negative lead (—)
first. After connecting the positive ter-
minal (+), securely place a cap on it to
prevent short circuits.
1. Battery cord (red)
2. Battery cord (black)
CAUTION
0)6'B(85B(1B1ERRN࣮࣌ࢪ㸰㸮㸯㸲ᖺ㸯㸰᭶㸰㸱᪥ࠉⅆ᭙᪥ࠉ༗ᚋ㸴㸲㸯ศ
To Next Page
Loading...
Need help?
General
