ENGINE OPERATION34
7
ENON00010-0
Note
Start-in-gear protection prevents engine
from starting at other than neutral shift. In-
gear starting of engine will move the boat
immediately, potentially leading to falling
down or causing passenger(s) to be thrown
overboard.
Tiller handle type
1. Be sure to install the stop switch lock
to the stop switch, and attach the stop
switch lanyard securely to the operator
or to the operator's PFD (Personal Flo-
tation Device.)
1. Stop switch lock
2. Set the control lever in the Neutral
position.
1. Shift lever
3. Set the throttle grip to START position.
1. Throttle grip
4. Pull the choke knob fully.
1. Choke knob
ENON00501-0
Note
Choke is not necessary when the engine is
warm. Set the throttle grip to “RE-START”
position.
ENON00502-0
Note
If engine does not start with 4 or 5 times
starting operation, push the knob back and
restart.
(For manual starter type)
This engine is equipped with a compres-
sion release mechanism.
0)6'B(85B(1B1ERRN࣮࣌ࢪ㸰㸮㸯㸲ᖺ㸯㸰᭶㸰㸱᪥ࠉⅆ᭙᪥ࠉ༗ᚋ㸴㸲㸯ศ
To Next Page
Loading...
Need help?
General
