PRE-OPERATING PREPARATIONS30
6
1. Air vent screw
2. Fuel tank cap
2. Loosen the tank cap until it contacts
the tab lock and release internal
pressure completely. After that, press
down the tab lock and open the tank
cap.
3. Fill the fuel carefully not to over flow.
4. After filling the tank, close the fuel
tank cap until two clicks sound is
heard.
ENOM00037-D
ENOW00022-1
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before starting engine.
ENOW00092-A
z Do not overfill engine oil, or engine oil
could leak and/or engine could be dam-
aged. If engine oil level is over upper limit
marks of oil gauge, drain oil to level lower
than upper limit.
z Be sure that outboard motor is in upright
and level position when checking or
changing oil.
z Stop engine immediately if low oil pres-
sure warning lamp is lit or oil leak is found,
or engine could be severely damaged.
Consult dealer.
z Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
1. Place the engine in a vertical posi-
tion.
2. Remove the top cowl and the oil filler
cap.
3. Fill the engine through filler port with
recommended oil to between upper
limit and lower limit shown on the
dipstick.
4. Tighten the oil filler cap.
1
2
ENOF00029-0
SAFE FILL
LEVEL
25 L
NIVEAU
MAXIMUM
ENOF00030-A
3. Engine oil filling
CAUTION
CAUTION
To Next Page
Loading...
Need help?
General
