ENGINE OPERATION38
7
tilted up. Otherwise, fuel could overflow.
ENOM00045-A
ENOW00958-0
z Do not remove or install the top cowl
after the engine has been started.
z The exposed rotating engine parts or
moving parts cause serious injury.
ENOW00959-0
The top cowl must be installed while the
engine running except in an emergency. If
the top cowl is not installed correctly, water
splash can damage the engine.
ENOW00036-A
When the engine is started in the test tank,
to avoid over heating and water pump dam-
age, be sure the water level is at least 10 cm
(4 in.) above the anti ventilation plate.
And be sure to remove the propeller, when
starting the engine in the test tank. (See
page 76)
Run the engine only at idling.
1. Test t ank
2. Water
3. Over 10 cm (4 in.)
ENOW00036-0
Be sure to stop engine immediately if cooling
water check port is not discharging water,
and check if cooling water intake is blocked.
Operating engine could lead to overheating
potentially leading to engine damage. Con-
sult an authorized dealer if the cause cannot
be found.
ENOW00032-A
Do not keep turning starter motor for over 5
seconds, or the battery may be consumed,
potentially making the engine starting
impossible and/or damaging the starter.
If cranking over 5 seconds fails to start
engine, return main switch to “ON”, and
crank engine again after 10 seconds or more.
Do not try to crank after engine has started.
This model is provided with start in gear
protection.
ENON00010-0
Note
Start-in-gear protection prevents engine
from starting at other than neutral shift.
In-gear starting of engine will move the
boat immediately, potentially leading to
falling down or causing passenger(s) to be
thrown overboard.
2. Starting the engine
WARNING
CAUTION
CAUTION
CAUTION
CAUTION
To Next Page
Loading...
Need help?
General
