TOHATSU MFS 25C User Manual

ENGINE OPERATION 45
7
ENOM00044-0
Engine speeds
Idling speed after warming up.
Remark: In case of cold engine starting,
idling speed is increased about 400 min
-1
(rpm) for several minutes.
ENOM00972-0
Free throttle lever (Side mount RC
type)
ENOW00956-0
z Keep the free throttle lever fully closed-
position when start the engine.
z The free throttle lever is inoperative
unless the

control lever is in neutral.
z Also, the control lever is inoperative
unless the free throttle lever is returned
to the fully-closed position.
The free throttle lever is for warm-up
operation.(Not required for engine start-
ing) With the control lever in neutral,
move the free throttle lever upward to
open the throttle.
1. Fully-open
2. Fully-closed
ENOM00-0
Trolling engine speed control
function (except for normal tiller
handle type)
If the main switch key is pressed for 1
(one) second during idling or trolling
operation, engine revolution change.
Each time the main switch key is pressed
in the above manner, engine speed
changes as follows.
Starting
850min
-1
(rpm)
Ѝ
950min
-1
(rpm)
ЌࠉࠉࠉࠉࠉЎ
950min
-1
(rpm)
Ћ
1050min
-1
(rpm)
Buzzer short sounded one time, when set
to 850 min
-1
(rpm) engine speed, and tells
the lowest engine speed was set.
Buzzer short sounded twice, when set to
1050 min
-1
(rpm) engine speed, and tells
the highest engine speed was set.
Reset the engine speed when after
engine restarted and or engine speed is
above 3,000 min
-1
(rpm), and then trolling
engine speed to be 850 min
-1
(rpm) as
standard.
In addition, this function does not oper-
ate when battery voltage is lower than
specified, set engine idle and trolling
engine speed to 850 min
-1
(rpm) auto-
matically.
Clutch in (In gear) Clutch off (Out of gear)
850 min
-1
(rpm) 850 min
-1
(rpm)
CAUTION
1
2
ENOF00934-0
ON
1second
ENOF00876-0

TOHATSU MFS 25C Specifications

General

Brand	TOHATSU
Model	MFS 25C
Category	Outboard Motor
Language	English