ENGINE OPERATION 45
7
the boat to be thrown forward due to iner-
tial force.
Tiller handle type
1. Turn the throttle grip to the slow posi-
tion.
1. Throttle grip
2. Put the shift lever in the Neutral posi-
tion.
Run the engine for 2-3 minutes at
idling speed for cooling down if it has
been running at full speed.
3. Push the stop switch for a few sec-
onds to stop the engine.
4. Turn the main switch key to the OFF
position or push the stop switch. ( Do
not forget to turn the key off).
Side mount RC type
1. Put the control lever in the Neutral
position and run the engine for 2-3
minutes at idling speed for cooling
down if it has been running at full
speed.
2. Turn the main switch key to the OFF
position or push the stop switch. ( Do
not forget to turn the key off).
1. Control lever
2. Mine switch key
ENOW00869-0
After stopping the engine:
Close the air vent screw on the fuel tank
cap.
Disconnect the fuel connector of the
engine and the fuel tank.
Disconnect the battery cord, after each
use.
To Next Page
Loading...
Need help?
General
